The loop that runs through the shed is now complete; it is essentially a large passing siding but I plan to put some scenery that suggests a township behind it.
I now have a function loop of track to run trains on as I work on the two point to point sections of the layout as well as getting the servo controlled points working..
My 1:20.3 Bachmann Consolidation (Connie) was used for a few test runs as it is the largest wheelbase with the biggest overhang of all my locos and all went well.
Track into LHS of Shed 
Track Loop crossing Shed under Upper Shelf
 |
| Loop Curving toward RHS of shed |
 |
| Track into RHS of Shed |
Included in the loop is a 3D printed G scale point (link below), this is the first time I have used 3D printed track work so I will watch it with interest. As it is out of the sun it should last a fairly long time.
No comments:
Post a Comment